47113 Camera CAM: LED driver board(s) not detected Did not detect the LED driver boards. Check the following connections: check that the LED_BRD cable is plugged into J18 on the GMCE (provides 12V to the camera) check that the LED driver board readback is plugged into the GMCE spare IO connector J14 Use the "gmce power" command to make sure that AI_5V_I is within 1 volt of 5V. If this is not the case then power off the machine, unplug the LED_BRD cable from J18 and reboot and retry. A short in the connector, LED driver board or the cable/connectors leading from the LED driver board to the camera could be the cause. check that the LED driver board cable is connected to J1 (CTRL_IN) of the first LED driver board and J2 (CTRL_OUT) of the last LED driver board. ensure that no cables have been caught under the camera mounting block check that the cable daisy-chaining the LED driver boards is connected at both ends This error is reported. Cable not connected. 08-Apr-2006 Added. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:51 2008 PST